On one of the forums (fora?) that I inhabit the subject of punch and die sets came up. While answering the ops question about the punch and die sets I use, I thought it was time I write more about the tools I use and so with some spare time on my hands today I wrote a new section under the tools section for these highly useful, if not often talked about, tools. More below…
There’s four new pages, one master page, and one for each tool listed below:
- Beading tool – for making rivets and bolt ends,
- Hexagonal punch and die – for making bolt heads, and
- Waldron’s punch and die sets (plural) – for making washers, panel overlays, cutouts, and anything else you can think to use them for.
To reach each page you can use the menu at the top of the page (modelling articles > tools ‘n’ tips > Punch and Die tools > choose an option), or click from the links below:
A note on safety
When using any tool, but especially those that cut or punch make sure you are wearing eye protection at all times. Small parts can and will fly into your eyes if you are not careful. I’m not responsible for any damage to you or others from using the information presented here.